This is a sliding gear that fits a 3-speed transmission. Fits Ford 8-cylinder 1957-62, Ford 6-cylinder 1957-62, Ford Truck 1960-63, Edsel 1959, 332 Eng. The numbers for the part are: TG-259-12D and MFRS NO. COAR-7100A. It was remanufactured and has been in storage for several years. New old stock. Made by International Parts Corporation. If you have any questions, call Bill at (606)269-4906.
This is a low gear that fits a 3-speed transmission. Fits 1963 Fairlane 289 engine, Ford 352-390engines , Mercury 390 engine. The number for the part is: 288-12. It was remanufactured and has been in storage for several years. It was remanufactured by the SOSMetal Company. New old stock. If you have any questions, call Bill at (606)269-4906.
This is a Classic Chevrolet reverse gear for models made in the 1950's and '60's. Fits: Chevys 1955-63 without overdrive and 1958-63 with overdrive. The number for the part is AWT-266 10 D. It was remanufactured and has been in storage for several years. It was remanufactured by the Perfection Gear Company. It fits a 3-speed transmission. If you have any questions, call Bill at (606)269-4906.Ne...
Similar
For Sale. Brown CJ hardtop, good condition, hatch, latch, all glass good, no cracks or repairs, could use paint. Two rebuildable 258 six cyl. engines, $200 each. Also a 258 6 cyl., 3 spd. trans., transfer case, drive lines and rear ends in tact with some frame rust. $600. Another frame repairable rust on frame rails, tub, and rear ends in tact rolling. $500. Two dash panels with gauges, $150. C...
For Sale as individually listed and priced or $1600 for entire lot. Two complete 258 6 cylinder engines both non-running, $200 each or $300 for both. One frame with engine, three speed trans, transfer case, rear-ends, and drive shafts in tact, repairable rust on both frame rails, $650. Second one, rolling chassis, repairable rust on both frame rails, $500. Repairable CJ 7 tub, $300. Two dash pa...
T56 6speed from a 94 camaro z28. 140,000 miles. bellhousing, clutch fork, shifter, and trans. I have the entire car if you want a full manual swap we can talk about that.I pulled it to put a new clutch in and before it was done i got my license suspended.Smooth shifting, great trans, in any gear you can throttle it hard, let up and gun it again and wouldnt pop out of gear. 93-97 fits the old sc...
Text or Email OnlyI would like to buy a good Ford Truck T19 CLOSE RATIO 4 speed transmission. MUST be 2wd or 4wd that originally had a divorced transfer case and have the 4.02 close ratio first gear. These are typically found in 1983-1987 460s and Diesels. Small blocks usually got the wide ratio 5.1 or 6.68. Not interested in the 5.1 or 6.68 versions. Also Im not desperate for one know these tr...
PLEASE LOOK AT LOCATION AND BE WILLING TO COME GET PARTS BEFORE TEXTING ME ABOUT THEM. REFER TO MAP, ITS SIMPLE.PLEASE TEXT OR EMAIL no callsIf its listed its still available.Parting out a 2003 crown Vic PI. No engine or trans. Great body except drivers fender. Driver door is missing molding and has some paint discoloration. Rear axle is 3.27 non locker Z code. Not for sale is the front suspens...
Please Email or Text, due to constant scammer calls unknown callers go to my block list.For sale is a nice clean Borg Warner T18 4 speed Transmission from a Ford 2wd. Complete with shifter, bellhousing, and rear yoke. Feels great rotating and shifting through gears. Bellhousing is for a small block and is also in nice clean condition. I believe this trans was built in 1983. Price is $400 with b...
PLEASE LOOK AT LOCATION AND BE WILLING TO COME GET PARTS BEFORE TEXTING ME ABOUT THEM. REFER TO MAP, ITS SIMPLE.And to everyone who is looking for something for nothing and you know who you are Youll pay a fair price or youll not get anything from me. If it doesnt sell it just goes in my mountain of scrap. No giveaways herePLEASE TEXT OR EMAILIf its listed its still available.Parting out a 2003...